§ 2.947   Measurement procedure.

   (a) The Commission will accept data which have been measured in
   accordance with the following standards or measurement procedures:

   (1) Those set forth in bulletins or reports prepared by the
   Commission's Office of Engineering and Technology. These will be issued
   as required, and specified in the particular part of the rules where
   applicable.

   (2) Those acceptable to the Commission and published by national
   engineering societies such as the Electronic Industries Association,
   the Institute of Electrical and Electronic Engineers, Inc., and the
   American National Standards Institute.

   (3) Any measurement procedure acceptable to the Commission may be used
   to prepare data demonstrating compliance with the requirements of this
   chapter.

   (b) Information submitted pursuant to paragraph (a) of this section
   shall completely identify the specific standard or measurement
   procedure used.

   (c) In the case of equipment requiring measurement procedures not
   specified in the references set forth in paragraphs (a) (1) and (2) of
   this section, the applicant shall submit a detailed description of the
   measurement procedures actually used.

   (d) A listing of the test equipment used shall be submitted.

   (e) If deemed necessary, the Commission may require additional
   information concerning the measurement procedures employed in obtaining
   the data submitted for equipment authorization purposes.

   [ 42 FR 44987 , Sept. 8, 1977, as amended at  44 FR 39181 , July 5, 1979;
    51 FR 12616 , Apr. 14, 1986]

   return arrow Back to Top