Goto Section: 101.107 | 101.111 | Table of Contents

FCC 101.109
Revised as of October 2, 2015
Goto Year:2014 | 2016
§ 101.109   Bandwidth.

   (a) Each authorization issued pursuant to these rules will show, as the
   emission designator, a symbol representing the class of emission which must
   be prefixed by a number specifying the necessary bandwidth. This figure does
   not necessarily indicate the bandwidth actually occupied by the emission at
   any instant. In those cases where part 2 of this chapter does not provide a
   formula  for  the computation of the necessary bandwidth, the occupied
   bandwidth may be used in the emission designator.

   (b) Stations in this service will be authorized any type of emission, method
   of modulation, and transmission characteristic, consistent with efficient
   use of the spectrum and good engineering practice, except that Type B,
   damped-wave emission will not be authorized.

   (c) The maximum bandwidth which will be authorized per frequency assigned is
   set out in the table that follows. Regardless of the maximum authorized
   bandwidth specified for each frequency band, the Commission reserves the
   right to issue a license for less than the maximum bandwidth if it appears
   that  a lesser bandwidth would be sufficient to support an applicant's
   intended communications.
     Frequency band (MHz)     Maximum authorized bandwidth
   928 to 929                 25 kHz^1 5 6
   932 to 932.5, 941 to 941.5 12.5 kHz^1 5 6
   932.5 to 935, 941.5 to 944 200 kHz^1
   952 to 960                 200 KHz^1 5 6
   1,850 to 1,990             10 MHz^1
   2,110 to 2,130             3.5 MHz
   2,130 to 2,150             800 or 1600 KHz^1
   2,150 to 2,160             10 MHz
   2,160 to 2,180             3.5 MHz
   2,180 to 2,200             800 or 1600 KHz^1
   2,450 to 2,483.5           625 KHz^2
   2,483.5 to 2,500           800 KHz
   3,700 to 4,200             20 MHz
   5,925 to 6,425             ^160
   6,425 to 6,525             25 MHz
   6,525 to 6,875             30 MHz.^1
   6,875 to 7,125             25 MHz^1
   10,550 to 10,680           5 MHz^1
   10,700 to 11,700           ^180
   12,200 to 12,700^8         500 megahertz
   12,700 to 13,150           50 MHz
   13,200 to 13,250           25 MHz
   17,700 to 18,140           220 MHz^1
   18,140 to 18,142           2 MHz
   18,142 to 18,580           6 MHz
   18,580 to 18,820           20 MHz^1
   18,820 to 18,920           10 MHz
   18,920 to 19,160           20 MHz^1
   19,160 to 19,260           10 MHz
   19,260 to 19,700           220 MHz^1
   21,200 to 23,600           50 MHz^1 4
   24,250 to 25,250           40 MHz^7
   27,500 to 28,350           850 MHz
   29,100 to 29,250           150 MHz
   31,000 to 31,075           75 MHz
   31,075 to 31,225           150 MHz
   31,225 to 31,300           75 MHz
   38,600 to 40,000           50 MHz^7
   71,000 to 76,000           5000 MHz
   81,000 to 86,000           5000 MHz
   92,000 to 95,000           (^3)

   ^1The  maximum  bandwidth  that will be authorized for each particular
   frequency in this band is detailed in the appropriate frequency table in
   § 101.147.    If    contiguous   channels   are   aggregated   in   the
   928-928.85/952-952.85/956.25-956.45 MHz, the 928.85-929/959.85-960 MHz, or
   the 932-932.5/941-941.5 MHz bands, then the bandwidth may exceed that which
   is listed in the table.

   ^21250 KHz, 1875 KHz, or 2500 KHz on a case-by-case basis.

   ^3To be specified in authorization. For the band 92 to 95 GHz, maximum
   bandwidth is licensed in one segment of 2 GHz from 92-94 GHz and one 0.9 GHz
   segment from 94.1 to 95 GHz, or the total of the loaded band if smaller than
   the assigned bandwidth.

   ^4For exceptions, see § 101.147(s).

   ^5A 12.5 kHz bandwidth applies only to frequencies listed in § 101.147(b)(1)
   through (4).

   ^6For frequencies listed in § 101.147(b)(1) through (4), consideration will
   be given on a case-by-case basis to authorizing bandwidths up to 50 kHz.

   ^7For channel block assignments in the 24,250-25,250 MHz and 38,600-40,000
   MHz bands, the authorized bandwidth is equivalent to an unpaired channel
   block assignment or to either half of a symmetrical paired channel block
   assignment. When adjacent channels are aggregated, equipment is permitted to
   operate over the full channel block aggregation without restriction.

   Note to footnote 7: Unwanted emissions shall be suppressed at the aggregate
   channel block edges based on the same roll-off rate as is specified for a
   single channel block in § 101.111(a)(1) or in § 101.111(a)(2)(ii) and (iii) as
   appropriate.

   ^8For incumbent private operational fixed point-to-point stations in this
   band (those not licensed as MVDDS), the maximum bandwidth shall be 20 MHz.

   [ 61 FR 26677 , May 28, 1996, as amended at  61 FR 44181 , Aug. 28, 1996;  62 FR 23167 , Apr. 29, 1997;  62 FR 24582 , May 6, 1997;  63 FR 6105 , Feb. 6, 1998;  65 FR 17449 , Apr. 3, 2000;  65 FR 38329 , June 20, 2000;  65 FR 59358 , Oct. 5,
   2000;  67 FR 43038 , June 26, 2002;  68 FR 4956 , Jan. 31, 2003;  69 FR 3266 ,
   Jan. 23, 2004;  70 FR 29997 , May 25, 2005;  75 FR 41771 , July 19, 2010;  76 FR 59572 , Sept. 27, 2011;  77 FR 54432 , Sept. 5, 2012]

   return arrow Back to Top


Goto Section: 101.107 | 101.111

Goto Year: 2014 | 2016
CiteFind - See documents on FCC website that cite this rule

Want to support this service?
Thanks!

Report errors in this rule. Since these rules are converted to HTML by machine, it's possible errors have been made. Please help us improve these rules by clicking the Report FCC Rule Errors link to report an error.
hallikainen.com
Helping make public information public