Goto Section: 2.108 | 2.202 | Table of Contents

FCC 2.201
Revised as of October 1, 2013
Goto Year:2012 | 2014
§  2.201   Emission, modulation, and transmission characteristics.

   The following system of designating emission, modulation, and
   transmission characteristics shall be employed.

   (a) Emissions are designated according to their classification and
   their necessary bandwidth.

   (b) Three symbols are used to describe the basic characteristics of
   emissions. Emissions are classified and symbolized according to the
   following characteristics:

   (1) First symbol--type of modulation of the main carrier;

   (2) Second symbol--nature of signal(s) modulating the main carrier;

   (3) Third symbol--type of information to be transmitted.

   Note to paragraph ( b ): Two additional symbols for the classification
   of emissions may be added for a more complete description of an
   emission. See Appendix 1, Sub-Section IIB of the ITU Radio Regulations
   for the specifications of these fourth and fifth symbols. Use of these
   symbols is not required by the Commission.

   (c) First Symbol--types of modulation of the main carrier:
      (1) Emission of an unmodulated carrier N
      (2) Emission in which the main carrier is amplitude-modulated
   (including cases where sub-carriers are angle-modulated):
   --Double-sideband A
   --Single-sideband, full carrier H
   --Single-sideband, reduced or variable level carrier R
   --Single-sideband, suppressed carrier J
   --Independent sidebands B
   --Vestigial sideband C
      (3) Emission in which the main carrier is angle-modulated:
   --Frequency modulation F
   --Phase modulation G

   Note: Whenever frequency modulation "F" is indicated, Phase modulation
   "G" is also acceptable.
      (4) Emission in which the main carrier is amplitude and
   angle-modulated either simultaneously or in a pre-established sequence
   D
      (5) Emission of pulses: ^1
   --Sequence of unmodulated pulses P
   --A sequence of pulses:
   --Modulated in amplitude K
   --Modulated in width/duration L
   --Modulated in position/phase M
   --In which the carrier is angle-modulated during the period of the
   pulse Q
   --Which is a combination of the foregoing or is produced by other means
   V
      (6) Cases not covered above, in which an emission consists of the
   main carrier modulated, either simultaneously or in a pre-established
   sequence, in a combination of two or more of the following modes:
   amplitude, angle, pulse W
      (7) Cases not otherwise covered X

   ^1 Emissions where the main carrier is directly modulated by a signal
   which has been coded into quantized form (e.g. pulse code modulation)
   should be designated under (2) or (3).

   (d) Second Symbol--nature of signal(s) modulating the main carrier:
      (1) No modulating signal 0
      (2) A single channel containing quantized or digital information
   without the use of a modulating sub-carrier, excluding time-division
   muliplex 1
      (3) A single channel containing quantized or digital information
   with the use of a modulating sub-carrier, excluding time-division
   multiplex 2
      (4) A single channel containing analogue information 3
      (5) Two or more channels containing quantized or digital information
   7
      (6) Two or more channels containing analogue information 8
      (7) Composite system with one or more channels containing quantized
   or digital information, together with one or more channels containing
   analogue information 9
      (8) Cases not otherwise covered X

   (e) Third Symbol--type of information to be transmitted: 2

   2  In this context the word "information" does not include information
   of a constant, unvarying nature such as is provided by standard
   frequency emissions, continuous wave and pulse radars, etc.
      (1) No information transmitted                N
      (2) Telegraphy--for aural reception           A
      (3) Telegraphy--for automatic reception       B
      (4) Facsimile                                 C
      (5) Data transmission, telemetry, telecommand D
      (6) Telephony (including sound broadcasting)  E
      (7) Television (video)                        F
      (8) Combination of the above                  W
      (9) Cases not otherwise covered               X

   (f) Type B emission: As an exception to the above principles, damped
   waves are symbolized in the Commission's rules and regulations as type
   B emission. The use of type B emissions is forbidden.

   (g) Whenever the full designation of an emission is necessary, the
   symbol for that emission, as given above, shall be preceded by the
   necessary bandwidth of the emission as indicated in §  2.202(b)(1).

   [ 49 FR 48697 , Dec. 14, 1984, as amended at  75 FR 63030 , Oct. 13, 2010]

   return arrow Back to Top


Goto Section: 2.108 | 2.202

Goto Year: 2012 | 2014
CiteFind - See documents on FCC website that cite this rule

Want to support this service?
Thanks!

Report errors in this rule. Since these rules are converted to HTML by machine, it's possible errors have been made. Please help us improve these rules by clicking the Report FCC Rule Errors link to report an error.
hallikainen.com
Helping make public information public