§  80.209   Transmitter frequency tolerances.

   (a) The frequency tolerance requirements applicable to transmitters in
   the maritime services are shown in the following table. Tolerances are
   given as parts in 106 unless shown in Hz.
   Frequency bands and categories of stations Tolerances ^1
   (1) Band 100-525 kHz:
   (i) Coast stations:
   For single sideband emissions 20 Hz.
   For transmitters with narrow-band direct printing and data emissions 10
   Hz ^2
   For transmitters with digital selective calling emissions 10 Hz.
   For all other emissions 100.
   (ii) Ship stations:
   For transmitters with narrow-band direct printing and data emissions 20
   Hz.
   For transmitters with digital selective calling emissions 10 Hz ^2
   For all other transmitters 10 Hz.
   (iii) Ship stations for emergency only:
   For all emissions 20 Hz.
   (iv) Survival craft stations:
   For all emissions 20 Hz.
   (v) Radiodetermination stations:
   For all emissions 100.
   (2) Band 1600-4000 kHz:
   (i) Coast stations and Alaska fixed stations:
   For single sideband and facsimile 20 Hz.
   For narrow-band direct printing and data emissions 10 Hz. ^2
   For transmitters with digital selective calling emissions 10 Hz. ^2
   For all other emissions 50 Hz.
   (ii) Ship stations:
   For transmitters with narrow-band direct printing and data emissions 10
   Hz. ^2
   For transmitters with digital selective calling emissions 10 Hz. ^3
   For all other transmitters 20 Hz.
   (iii) Survival craft stations: 20 Hz.
   (iv) Radiodetermination stations:
   With power 200W or less 20.
   With power above 200W 10.
   (3) Band 4000-27500 kHz:
   (i) Coast stations and Alaska fixed stations:
   For single sideband and facsimile emissions 20 Hz.
   For narrow-band direct printing and data emissions 10 Hz. ^2
   For digital selective calling emissions 10 Hz.
   For Morse telegraphy emissions 10.
   For all other emissions 15 Hz.
   (ii) Ship stations:
   For transmitters with narrow-band direct printing and data emissions 10
   Hz. ^2
   For transmitters with digital selective calling emissions 10 Hz. ^3
   For all other transmitters 20 Hz.
   (iii) Survival craft stations: 50 Hz.
   (4) Band 72-76 MHz:
   (i) Fixed stations:
   Operating in the 72.0-73.0 and 75.4-76.0 MHz bands 5.
   Operating in the 73.74.6 MHz band 50.
   (5) Band 156-162 MHz:
   (i) Coast stations:
   For carriers licensed to operate with a carrier power:
   Below 3 watts 10.
   3 to 100 watts 5. ^7
   (ii) Ship stations 10. ^4
   (iii) Survival craft stations operating on 121.500 MHz 50.
   (iv) EPIRBs:
   Operating on 121.500 and 243.000 MHz 50.
   Operating on 156.750 and 156.800 MHz. ^6 10.
   (6) Band 216-220 MHz:
   (i) Coast stations:
   For all emissions 5.
   (ii) Ship stations:
   For all emissions 5.
   (7) Band 400-466 MHz:
   (i) EPIRBs operating on 406-406.1 MHz 5.
   (ii) On-board stations 5.
   (iii) Radiolocation and telecommand stations. 5.
   (8) Band 1626.5-1646.5 MHz:
   (i) Ship earth stations 5.

   ^1 Transmitters authorized prior to January 2, 1990, with frequency
   tolerances equal to or better than those required after this date will
   continue to be authorized in the maritime services provided they retain
   approval and comply with the applicable standards in this part.

   ^2 The frequency tolerance for narrow-band direct printing and data
   transmitters installed before January 2, 1992, is 15 Hz for coast
   stations and 20 Hz for ship stations. The frequency tolerance for
   narrow-band direct printing and data transmitters approved or installed
   after January 1, 1992, is 10 Hz.

   ^3 [Reserved]

   ^4 For transmitters in the radiolocation and associated telecommand
   service operating on 154.584 MHz, 159.480 MHz, 160.725 MHz and 160.785
   MHz the frequency tolerance is 15 parts in 10 ^6.

   ^5 [Reserved]

   ^6 [Reserved]

   ^7 For transmitters operated at private coast stations with antenna
   heights less than 6 meters (20 feet) above ground and output power of
   25 watts or less the frequency tolerance is 10 parts in 10 ^6.

   (b) When pulse modulation is used in land and ship radar stations
   operating in the bands above 2.4 GHz the frequency at which maximum
   emission occurs must be within the authorized bandwidth and must not be
   closer than 1.5/T MHz to the upper and lower limits of the authorized
   bandwidth where "T" is the pulse duration in microseconds. In the band
   14.00-14.05 GHz the center frequency must not vary more than 10 MHz
   from 14.025 GHz.

   (c) For stations in the maritime radiodetermination service, other than
   ship radar stations, the authorized frequency tolerance will be
   specified on the license when it is not specified in this part.

   [ 51 FR 31213 , Sept. 2, 1986, as amended at  52 FR 7418 , Mar. 11, 1987;
    53 FR 37308 , Sept. 26, 1988;  54 FR 49994 , Dec. 4, 1989;  57 FR 26778 ,
   June 16, 1992;  58 FR 33344 , June 17, 1993;  62 FR 40306 , July 28, 1997;
    63 FR 36606 , July 7, 1998;  68 FR 46964 , Aug. 7, 2003;  76 FR 67611 , Nov.
   2, 2011]

   return arrow Back to Top